耐普UPS蓄电池安装前注意事项：

1、检查NPP电池无异常，将其安装在指定地点（如电池房）。

2、避免耐普电池安装在靠近热源（如变压器）的地方。

3、如将电池安放在电池房，应尽可能将其放在电池房最低处。

4、因为耐普蓄电池贮存时可能产生易燃气体，安装时应避免靠近产生火花的装置(如保险丝)。

5、连接前，擦亮电池端子，使其呈现金属光泽。

6、小心导电材料短接电池正负端子。

7、多个耐普电池一起使用时，首先保证电池间连接正确，再将电池与电源设备或负载连接。在这种情况下，电池正极与电源设备或负载的正负极连接，负极与负极连接。如果电池与电源设备连接不正确，电源设备会被损坏，一定要注意不要连接错误，切记正负极连接正确。

8、接线时注意要连接牢固，每个连接螺母与螺栓一定要扭紧，但不可用力过大，以免损伤端子。

1. Check that NPP battery is normal and install it in the designated place (such as battery room).

2. Avoid installing the battery near a heat source (such as a transformer).

3. If the battery is placed in the battery room, it should be placed in the lowest place of the battery room as far as possible.

4, because the storage battery can produce flammable gas, installation should avoid close to the spark device (such as fuse).

5. Before connection, polish the battery terminal to give it a metallic luster.

6. Be careful to connect the positive and negative terminals with conductive materials.

7. When multiple napp batteries are used together, first ensure the correct connection between the batteries, and then connect the batteries to the power supply device or load.In this case, the positive pole of the battery is connected to the positive and negative pole of the power supply device or load, and the negative pole is connected to the negative pole.If the battery is not properly connected to the power supply device, the power supply device will be damaged. Be careful not to make the wrong connection.

8, pay attention to the connection when wiring, each connection nut and bolt must be tightened, but not too strong, so as to avoid damage to the terminal.